Thrifty lighting for seed plot

hypothesis:
Photosynthesis was adapted to radiant energy of red light, to feeble sunlight in conditions of the ancient heavy atmosphere.
experiment:
Plants lighting with continuous non-pulse direct feeble red light.

Illumination device

Figure 1.
Electrical scheme with LEDs (ultra bright light-emitting diodes) for the lighting with continuous non-pulse direct red light.

Electric parameters and electronic elements for light-emitting diode scheme

U_input - pulse direct +14 Volts
C1 - electrical condenser 1000 microfarad (mcF), 25 Volts
R1 - 36 Ohms ballast resistor
D1-D12 - 5-millimetres ultra bright light-emitting diodes (LEDs) luminous intensity 5800-7000 mCd (millicandelas), red light wavelength 620-625 nm, maximal current 30 mA, viewing angle 20 degrees (crystal clear)
I_LEDs - non-pulsate direct current 47 mA (milliAmpere)
U_LEDs - 12.3 volts
 

Technical data
Input LEDs power: 0.58 Watts
Lighting area: 9 centimeters²

Additional soft red and blue lighting diodes

Electric parameters and electronic elements for blue light-emitting diode scheme

U_input - direct +14 Volts
R1 - 200 Ohms ballast resistor
D1, D2 - 5-millimetres blue ultra bright light-emitting diodes (LEDs), luminous intensity 5800-7000 mCd (millicandelas), blue light wavelength 475 nanometer, maximal current 30 mA, viewing angle 20 degrees (crystal clear)
I_LEDs - direct current 38 mA (milliAmpere)
U_LEDs - 6.65 volts
 

Electric parameters and electronic elements for red light-emitting diode scheme

U_input - direct +14 Volts
R1 - 250 Ohms ballast resistor
D1, D2 - 5-millimetres red ultra bright light-emitting diodes (LEDs), luminous intensity 5800-7000 mCd (millicandelas), red light wavelength 620-625 nanometre, maximal current 30 mA, viewing angle 20 degrees (crystal clear)
I_LEDs - direct current 42 mA (milliAmpere)
U_LEDs - 3.92 volts
 

Luminous flux pulsations of the artificial lighting sources is supplied by pulse direct current and non-pulse direct current

T  - 0.01 second for 50 Hertz (Hz) frequency or 0.008(3) sec for 60 Hertz frequency
U₁ - pulse voltage (direct current, DC)
U₂ - non-pulse voltage (direct current, DC)
F₁ - pulse luminous flux of light emitting diodes (LEDs), supplied by pulse voltage U₁
F₂ - non-pulse luminous flux of light emitting diodes (LEDs), supplied by non-pulse voltage U₂
F₃ - pulse luminous flux of incandescent light bulbs, supplied by pulse voltage U₁
F₄ - non-pulse luminous flux of incandescent light bulbs, supplied by non-pulse voltage.

  >> More articles - part Economical eco building and engineering